Sharkoon Light² 200 Review - Honeycomb Gamer Mouse Review Game-Tech
Sharkoon Light² 200 has an interesting design. Here is the Sharkoon Light² 200 review. What is the Sharkoon Light² 200 price?
With the Sharkoon Light² 200, the manufacturer is following the trend of lightweight gaming mice. A housing with countless hexagonal holes is also typical here. To be able to stand out from the competition, the manufacturer has a few gimmicks ready. Our test clarifies how these express themselves and what the overall impression is.
For a long time, weight played a rather subordinate role in gaming mice. This can also be seen from the fact that even mice with a weight adjustment system usually assumed a high basis weight. That a high mass makes the movements sluggish is actually no secret. For fast games, a low weight is an advantage, which is also evident in the Sharkoon Light² 200.
With the perforated cover, it weighs just 62g. It plays in a league with the Cooler Master MM711, SilentiumPC SPC Gear LIX Plus and Glorious PC Gaming Race Model O- and D-. The prices mentioned range from ~ 40 € to 54 €. The sensor is also almost tied. The Light² 200 and MM711 rely on the PMW3389, the others mentioned on the PMW3360. Special features can therefore be decisive when choosing a rodent.
With the Sharkoon Light² 200, the special features start with the scope of delivery. Also, the buyer receives a set of new skates, another cover for the back and three additional rubber DPI buttons.
The Sharkoon Light² 200 is designed for right-handers, which applies to almost all mice of the new genus. The same applies to the screened housing. The whole pattern is similar to that of the competition. Hexagons seem to be trendy too. There is a difference, for example, in the areas of the pattern. The sides, back and bottom are covered, but the two main keys are not. This is different from the competition, as they stretch back longer there.
The number of keys can also be identified as typical. In addition to the two main buttons, there are two thumb buttons, a DPI button and the sixth mouse wheel. All can be programmed. Unspecified Omron 20M switches are used for the main buttons.
One of the special features is the interchangeable cover for the back. This increases the weight of 62g by 3g. The shells hold magnetically on the housing and can be easily exchanged. The otherwise often mentioned problem of soiling can easily be counteracted. Inside, the electronics are protected by a potted cuboid. You can’t see anything of the actual PCB, so mechanical defects are actually excluded.
Another special feature is the DPI button. It can also be customized. Not only can the colour be changed, but also the thickness. The manufacturer says that this should improve accessibility.
Another function can be found on the bottom. A switch can be used to change the polling rate between 125Hz, 500Hz and 1000Hz. But this is not the only way to adjust the mouse that can be done without software. The shortcuts available are explained on the following page.
The software of the Light² 200 is very slim at ~ 4MB like the mouse itself, which is pleasing. Since you can create five profiles in the software, you may not need them after configuring them, as you can switch between the five profiles on the mouse using a shortcut. The keys can be programmed on the first page. The standard commands can be transferred or completely different actions can be stored. E.g. multimedia commands can also be created or a sniper button. The seven DPI levels can be configured on the second page. From 50 to 16,000 you can select your desired resolution in steps of 50, which is done using sliders. It is a bit of a shame, however, that you cannot enter your desired value directly. The levels can also be reduced. Not impractical, because you only dial through on the mouse. You can choose from 10 effects for the lighting. There is no adjustment of individual zones. Macros can also be created and saved on the mouse. Due to the limited number of buttons, this would probably only be used in conjunction with different profiles.
There are also three shortcuts on the mouse itself. You can use these to switch the lighting effects (right main button + front thumb button) and switch the five profiles (both main buttons + rear thumb button) and reset the mouse (both thumb buttons + scroll wheel). The buttons must always be pressed for three seconds.
You can tell from the first second that the Sharkoon Light² 200 is light. The weight is really no comparison to my otherwise used Corsair Nightsword RGB, which is almost twice as heavy without additional weights. It copes with the palm grip used by default without any problems. Their size is good enough that my hand can be completely laid down without the pad rubbing. The other types of handles can also be used. Even with the fingertip grip, it cuts a very good figure due to its low weight. With this, you can move the mouse even faster. But this is also due to the PTFE feet. The Corsair MM350it shows itself with very good sliding properties. The cable is not disturbing. And that although it is thicker than, for example, the Corsair I used the mouse. But it is much more flexible and less stiff. If you take it in your hand, you can feel that the fabric sleeve has simply been pulled up more loosely. Back to the design. The buttons are very well placed except for the DPI button. If you replace the DPI rubber with a thicker one, you can also trigger the button with the metacarpal bone instead of the fingertip, at least that’s the case with me. The keys’ pressure point is also good. The main keys feel crisp and have a relatively short release path. The pressure point of the mouse wheel, however, is very firm. Whether that suits you is a matter of taste. For me, it should be a little easier. The raster of the same, however, is weakly graded. Overall, I like the mouse very much from a subjective point of view.
So let’s first take a look at the accuracy of the resolution. At an average of ~ 5.9%, this is already relatively high. This is normal at the top, as the measurement is really difficult here, but similar deviations are also found in the lower area. That’s not really bad, because you can adjust to your comfort level, even if it differs from the actual number. For a quick switch to the mouse, however, a familiarization phase is required.
To be honest, I like the weight of my Corsair Nightsword RGB a thorn in the side for a while. So I was eagerly awaiting the Sharkoon Light² 200, which should be my first lightweight mouse. From the second she picked me up right away. The shape suits me very well, even a tad better than my actual rodent. The reason lies in the somewhat larger case, which makes it easier to put your hand down. Ultimately, I would still use the mouse with a slight mix of palm and claw grip, as this is the best way to ensure that the buttons can be reached. Also, the mouse remains very agile, which is also due to the good gliding feet. Since the cable is very flexible, it does not have a disruptive effect. In terms of shape, buttons and sensor, the mouse can convince overall.
The processing is also perfectly fine. Even though the cover can be changed at the top, the Light² 200 looks stable. However, it is not completely creak-free if you pick it up properly. But you don’t notice it in everyday life. The DPI switch, the shortcuts and the polling rate switch on the bottom allow many setting options “on-the-fly”, provided that the mouse has already been configured using the software. I also really like the fact that it is quite slim. However, it would be nice if you could enter the DPI levels manually and the colour assignment is also displayed here, which is visualized on the mouse by lighting. Whether the additional features really create personal added value is more likely to be assessed subjectively. I think it’s good that you deliver new mouse acts. They don’t really wear out on a fabric pad, but you never know.
When it comes to the price, I can’t complain about either. A comparable Cooler Master MM711 costs ~ 10 € more. For ~ 45 € you get a really good mouse and that in all points. If you are looking for a simple replacement for your rodent, I would throw the Sharkoon Light² 200 into the room as a tip. That is exactly why she receives this award from us
Sharkoon Light² General SummarySharkoon Light² To summarize, we see that it has very good features in terms of design, price and performance. Sharkoon Light², which has given a successful performance compared to its competitors in this segment, has not received any serious complaints from its users until now and has given its users confidence with maximum positive feedback. With the Sharkoon Light² 2-year warranty, it continues to support any problem after the sale and does not suffer the user.
Want to win? Sharkoon Light²Thanks to the campaign made with Amazon, our site gives gifts to a certain user every month. Sharkoon Light² Winning users are selected from our commenting users. The winners can be reached via e-mail. You can join the lottery by leaving a comment below this article. Please visit our site to make sure your comment is approved.
Installation of the Product is Extremely Simple. You can set it up easily with the included Guide.
Has no known chronic problems.
Yes, they say they are generally satisfied.
The minimum warranty period is 2 years.
You can buy it from sites like amazon, ebay.